New CCNA – Switch Questions 2
Question 1
What does a Layer 2 switch use to decide where to forward a received frame?
A. source MAC address
B. source IP address
C. source switch port
D. destination IP address
E. destination port address
F. destination MAC address
Answer: F
Question 2
The network administrator cannot connect to Switch1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on Switch1 to correct this problem?
A. Switch1 (config)# line con0
Switch1 (config-line)# password cisco
Switch1 (config-line)#login
B. Switch1 (config)# interface fa0/1
Switch 1(config-if)# ip address 192.168.24.3 255.255.255.0
C. Switch1 (config)# ip default-gateway 192.168.24.1
D. Switch1 (config)# interface fa0/1
Switch 1(config-if)# duplex full
Switch 1(config-if)# speed 100
E. Switch1 (config)# interface fa0/1
Switch 1(config-if)# switchport mode trunk
Answer: C
Question 3
How many broadcast domains are shown in the graphic assuming only the default vlan is configured on the switches?
A. one
B. six
C. twelve
D. two
Answer: A
Explanation
Only router can break up broadcast domains but in this exhibit no router is used so there is only 1 broadcast domain.
For your information, there are 7 collision domains in this exhibit (6 collision domains between hubs & switches + 1 collision between the two switches).
Question 4
Refer to the exhibit. Which of these statements correctly describes the state of the switch once the boot process has been completed?
A. As FastEthernet0/12 will be the last to come up, it will not be blocked by STP.
B. Remote access management of this switch will not be possible without configuration change.
C. More VLANs will need to be created for this switch.
D. The switch will need a different IOS code in order to support VLANs and STP.
Answer: B
Explanation
From the output we notice that the administrator has just shut down Interface Vlan1, which is the default VLAN so no one can access it remotely (like telnet) -> B is correct.
Answer A is not correct as STP calculation does not depend on which port comes up first or last. STP recalculates when there is a change in the network.
A normal switch can operate without VLAN -> C is not correct.
This IOS does support VLAN because it has VLAN 1 on it -> D is not correct.
q1, q3 today
question no 3 ans no cleared
hi gyes
anonymous
one network or one vlan =one broadcast domain
another network = another broadcast domain and
only router can saperate broadcast so there is no router on that topology and by default switch has only one vlan 1
please send me the latests dumps please my e-mail sandeepagarwal57@gmail.com
Q1 today
please send me the latests dumps please my e-mail almagablehahmad@yahoo.com
Hi guys..could any of you pls send over the latest dumps which you have..Thanks in advance!!
mail-id : arunachalam1987@gmail.com
Q1 Q3 in Today Exam
q2,q4 ….Dec 18
q3 on dec 11
Q3 Today
q2 today
q2 today
Q2 today
Pls send me the latest dumps for 200-120 CCNA Exam.
Pls send me the latest dumps for 200-120 CCNA Exam.
d.sheth5@gmail.com
Dear 9Tut Admin: Q.2 In appearance seems to be an inconsistent response since it has a missing graph depicting precisely where the admin is located trying to reach the Switch by telnet as well as the apparent excessive information regarding to the Router and the second Switch. If the Admin would be trying telnet or ping from the local subnetwork the problem preferably could be option A in my opinion. If oppositely the Admin is located in a non local subnetwork, a Default Gateway address must be neccesary at the Switch, as it seems is the case (Option C). Don’t you think so? Is there any chance to add the graph for more accurate description? Thanks.
Pls send me the latest dumps for 200-120 CCNA Exam.
maidulkuet@yahoo.com
Q1, Today, 1/12/14
Q1 in my exam today . Passed thanx 9tut
please i need the latest ccna dumps…my email address is chuks.egbo@stu.cu.edu.ng
@Claudio, Q2 cannot be answer A because it references the “line con0″ which is for using a console cable, not telnet over virtual terminal lines. Even without the image there was enough information to figure out the answer though the image would have been useful.
Dear 9tut readers if anyone has the latest dumps please send me on mirshamsudin@gmail.com.
with kind regards
Q1 Today
i intend to take CCNA test till 15th of this month. PLZ any one who has recently cleared the exam tell that are the questions coming from watson DUMPS ?? if yes kindly mail it to me. my id is tahir2710@gmail.com
Someone please send me the latest dumps for the CCNA exam. Thank you.
ericgraves2002@gmail.com
Question 2, please add picture or explanation.
of the 4 questions one of the questions says there is an exhibit but there is none, the question can’t be answered correctly without the exhibit
Passed yesterday with score 1000 Thank God
The exam was 51 questions, only one drag and drop about cable types, all questions are very easy just similar to 9tut.
The lab simulations were Eigrp , ACL1 (similar to 9tut exactly) and ACL2 (modification 3 but with host B to access the finance server)
Good luck for everyone, just be relaxed its very very easy :)
questions 1,3,4 were in it
can any please send me the dumps..have test tomorrow.
itsmejai@gmail.com
and also share vce 1.2 simulator
can any please send me the dumps..have test tomorrow.
itsmejai@yahoo.com
and also share vce 1.2 simulator
Please send me the latest dumps to guru.mysoruu@gmail.com
Q3 today
@Reysan Plz send me the latest dumps @ ksoban00@gmail.com
Please send me the latest dumps to jose.arsenal@gmail.com
Passed yesterday with score 1000 Thank God
There is no graphics shown with Q2. ?
please send me the latest dumps adnanahsan.neu@gmail.com
Passed my CCNA exam today (18th Mar)… Q1, Q2 and Q4 in exam
Hi, your MCQ’S are full of good thinks and your tips for Learning Path is clear.
For know about Cisco concept and Exam visit here :- http://ccnajaipur.org/
Pls hw much is ccna exam now bcos am planning to take my exam next month pls I also need latest vce to aid my practice
@adex the ccna 120-200 exam is 328 us dollar.
@jam signal ccna 120-200 exam is $295 as when you registered to pearson vue. :-)
Q1
can any one please send me the dumps
jaygadhia@gmail.com
and also share vce simulator
No graphic shown with Q2 !
Can someone Please share me dumps to zameer.ise@gmail.com
Thanks a lot in advance,
Jameer
Q1 5/23
Anyone please send me dumps to laryxnktmarshal@gmail.com I’ll kindly appreciate.